Home
Games
For Kids
For Parents
For Teachers

Site Overview

Electricity FAQs

Experiment Tips

Complete a Circuit

Conductors & Insulators

Electricity & Water

Ben Franklin Was Lucky!

Investigate Your School's Energy Habits

Student Worksheets

Worksheet Answer Keys

Going Further


Visit the Natural Gas Safety World Site

For Teachers > Experiment Tips > Electricity & Water
Electrical Safety World
Electricity & Water

Download Teacher's Guide

Go to the Experiment

This experiment is for students in grades 3–7. It appears in the section "How Electricity Can Hurt You."

Materials:

Students will need the circuits they made for the "Conductors & Insulators" experiment, plus a glass pint or quart jar, 2 nails, 2 alligator clips, salt, and water.

Safety First:

  • Students should be supervised by an adult while doing this experiment.

  • A teacher or another adult should be responsible for stripping insulation from wires.

  • Explain to students that anything can conduct electricity when wet. Remind students that they can mix water and electricity safely in this experiment because the voltage is so minimal (1.5 V per D-cell battery).
Objective:

Students will demonstrate that water is a conductor of electricity.

Getting It Across:

Be sure students add plenty of salt to the water. Then have them predict, experiment, and note their observations. Share results.

Questions and Answers:

Ask students why they think the salt is needed. (Students will need to add a lot of salt to their water in order for electric current to flow. The voltage of the battery is so low that additional particles must be added to make the water MORE conductive. It is the impurities in water that make it a good conductor. Pure water will not conduct electricity. However, pure water is only found in the laboratory. That's why there is so much emphasis on the conductivity of water as regards electrical safety.)

Previous Page  Next Page


Top of Page



Home Links Glossary Site Map
©2005 Culverco.com, LLC